steel roof roll forming machine
Below is our standard production line solution, according to customers' requirements from different countrys, we can provide various machine solutions to satisfy you at a best position. Our advantage is to design and making machine as per your particular profile drawing requirements.
Machine composition:
10Ton*1250mm Hydraulic un-coiler with coil car
Hydraulic system to expand coil inner hole, Pump motor: 5.5KW
Taper wedge expand type
Double level expanding palms with two coil bore variations of 480-530 for Palm 1 and 580-630 for Palm 2
Load Capacity: Max. 10 Tons; Coil Width Max. 1250mm
Coil Outer-diameter Max. 1500mm
Retarding Motor to turn the coil, Motor: 7.5KW
Slippage guiding equipped on the base frame. There is a hydraulic oil cylinder on the base to drive the un-coiler to make correction when the shaft-line is off-position with the forming machine, to make sure the generatrix of the coil consistent with the forming machine.
Maintain arm on the top, to avoid coil become loose when stop to be packed.
The arm to be driven by pneumatic cylinder, manual control
The air supplier should be provide by the user
With coil car – The original design
Up/Down stroke of Coil Car: Max. 450mm;
Forward/backward stroke of Coil Car: Max. 2000mm
http://chinarollingmachine.com/
Contact person： Anna Liu
Email: annaliu@czxindingli.com
Mobile&WhatsApp: +86 15532867977;
FAX: 86-317-8189190
没有评论:
发表评论